Restarted machineĨ) turned a small shaft and measured the center point of this in X and Y direction. (i do not care to much about accuracy for home zero for these two axes, it is only relative to the measuring probe anyway and I felt that the markers would make it good enough)Ģ) Moved X-axis and Y-axis to their marked Zero point.ģ) Mounted a measuring indicator in the rotating tool holderĤ) Using the indicator i rougly found the center of the chuck just to have a reference (by using the inner diameter)ĥ) Left Y axis at zero and moved X axis to the value stated in parameter 1250 (i think, have to double check)Ħ) Set APZ on these two axes from 1 to 0 to 1. you for the tip, buy oh wow that seems like a complicated way of doing it.ġ) Moved Z-axis and B-axis to their marked Zero point and set the zero for them by changing parameter 1815 APZ from 1 to 0 to 1 for the respective axis and restarted the machine. Organising a technician will be required to re position all the axes to their correct home positions then calibrating your tool setter, but to be fair, I have instructed remote savvy customers in the procedure over the phone before This is not a parameter problem this is zero position loss. We do have a disk with all the original machine parameters. They state that the encoders need to be calibrated for all of the X, Y, Z, and sub-spindle (B) axes, and that X and Y is difficult because the Y-axis uses the X-axis as slave. I am afraid they are just trying to exploit the situation. When I ask if it is possible to do this remotely he just say it is not possible. (our last visit from them landed in the 10 000 dollar range.) The problem is we are far away from them and they will bill a huge amount just on travel expenses.
MANUAL ARTCUT 2009 SEIKI SERIES T FULL
The service guy at the dealer in my country say they have to send a technician for a full day to fix this issue. PS0302 SETTING THE REFERENCE POSITION WITHOUT DOG IS NOT PERFORMED (after trying to zero the axes) The machine is a millturn DOOSAN PUMA 2600LSY with fanuc i-series control (Note i have tried searching the forum, but none of the previous threads have yielded a solution.) Over previous summer vacations we've had a voltage alarm, but never actually lost any parameters.
We had replaced the backup batteries on our machine this spring, so they were nowhere near old. Dear forum, I am in need of help regarding an APC alarm due to battery failiure over the summer vacation and I think the machine dealer is trying to rip me off.
0 kommentar(er)
